AWLGRIP 545 Εποξικό Αστάρι Βάση
€79.77 – €237.22Price range: €79.77 through €237.22
To Awlgrip 545 Epoxy Primer Είναι ένα αστάρι πολλαπλών χρήσεων, για εφαρμογή πάνω από στοκαρισμένες και επισκευασμένες επιφάνειες, προτού περαστεί η τελική βαφή Topcoat. Κατάλληλο για πάνω αλλά και κάτω από την ίσαλο γραμμή.
To Awlgrip 545 Epoxy Primer Είναι ένα αστάρι πολλαπλών χρήσεων, για εφαρμογή πάνω από στοκαρισμένες και επισκευασμένες επιφάνειες, προτού περαστεί η τελική βαφή Topcoat. Κατάλληλο για πάνω αλλά και κάτω από την ίσαλο γραμμή.
Surface Preparation
- Aluminum: Sandblast or grind to 100% clean silver color or treat with Alumiprep 33/Alodine 1201/
- Steel: Sandblast/grind SSPC-SP5-85 or Sa 2 1/2. Gelcoat/Fiberglass: Sand with 100-150 grit paper.
- Wood: Smooth sand with 80-100 grit paper.
Theoretical Coverage: 497 Sq feet/gallon at one mil dry (25 microns) 165-248 Sq. Feet at recommended dry film thickness. Calculated based on a theoretical transfer efficiency of 100%.
Mixing and Reduction:
This is a two part system. You must order the base primer in either gray or white along with the D3001 Converter in the appropriate size. The mix ratio is 1:1 so if you purchase 1 quart of primer you also need 1 quart of converter for a total of 2 quarts. Additionally you need to purchase the appropriate reducer (spray or brush) for spraying reduce up to 25% with T0006 and for brushing reduce up to 10% with T0031.
- Spray: Mix by volume one part 545 base with one part D3001 to a smooth homogenous mixture. Reduce up to 25% with T0006. Overall mix is 1:1 1/2 by volume. Example: 8 oz 545 base, 8 oz D3001, 4 oz T0006.
- Brush/Roll: Reduce 5-10% with T0031. Below 75 F you may use Cold Cure Accelerator M3066 to maintain dry and cure times. Anticipated Pot life at 77 F and 50% relative humidity is 16 hours.
Application:
- Spray Application: Apply smooth, wet coats to fill and cover surface profile. Two to 3 may be needed at 5 – 6.5 mils WFT yielding 2-3 mils DFT.
- Brush and Roller Application: Apply 2 coats at 3-4 mils WFT yielding 1.0 – 1.5 DFT per coat. Allow 12-14 hrs between coats. Light sanding between coats will improve appearance. For large surfaces rolling, then tipping with a brush is preferred. Do not apply paint materials to surfaces warmer than 105 F or colder than 55 F. Do not attempt to cure products at temperatures below 55 F.
Note: Do not apply paint materials to surfaces less than 3 C or 5 F above dew point or to surfaces warmer than 41 C or 105 F. Ambient temp should be a minimum 13 C / 55 F and max 41 C or 105 F.